The extruder is almost the most important part for 3D printer, also the most difficult part to calibrate. we have made necessary design to prevent "jammed" problem. I can't emphasize anymore how important this is, other sellers don't have this and would cause many problems.
(1)The extrude is with thermistor sensor.
(2)Compatible with ABS and PLA 1.75mm.
While using with PLA filament, please always remember to keep the fan on, otherwise it might get jammed and ruin the hotend. PLA is more easier to get jammed, so it might require some patience to practice.
For ABS, we would also suggest to keep the fan on, as this is also better. also remember to purchase filament from good reputation seller, as the filament is very important!
( default for this is with 0.4mm nozzle, and suitable for 1.75mm filament )
(4)Nozzle Flow Rate:24cc / h
(5)Thermistor Tpye:NTC 100K 3950
(6)Sports Shaft Speed:10-100mm
(3)Rated Voltage:2.55 V
(4)Rated Current:1.7 A
(6)Phase Resistance:2.3 mH
(7)Number of Lead Wire:10-100mm
(1)We have made necessary design to prevent "jammed" problem.
(2)The extrude is with thermistor sensor.
(3)Compatible with ABS and PLA 1.75mm.
(4)We not just sell them, we also provide good after-sales service, so welcome to discuss with us, we will try to do technical support as much as we can.